FAO SCHWARZ SXL2023T 5 Inch Glow UFO Drone Instruction Manual (2024)

FAO SCHWARZ SXL2023T 5 Inch Glow UFO Drone

INTRODUCTION

Congratulations on your purchase of the Drone Glow UFO. It's time for fun. This drone is capable of omnidirectional flight - fly up, down, left and right, pitch fonward or backward - all with 6-axis gyro stablization. Includes remote, USB charging cable and replacement Nadies. Drone features auto orientation. auto takeoff and lancino.Prepare For Flight

• Drone must be charged before each use (cable included).
• Indicator light on Drone will turn off when fully charged.
• Install batteries in remote.

• Turn your drone on and place on a flat, level surface.
• Turn on the remote.
• Push the left stick up and then down.
• Repeat the above steps in order if necessary.

• Left joystick: Controls elevation.
• Right joystick: Controls flight direction.
• Direction Trim: Reduces drone drift.
• Press the "Take Off / Land" button to take off and land.
• To cut power to drone, press and hold red STOP button.

GENERAL WARNINGS

SAFETY WARNINGS

• Not recommended for children under 14 years of age. As with all electrical products, precautions should be observed during handling and use to reduce the risk of electrical shock.
• Adult supervision is required at all times.
• Never fly drones above or near people. Sudden changes in wind or other conditions could lead to unexpected crashes.
• Always use caution when flying drone vehicles, obey relevant laws, respect the privacy and property rights of others. The drone shall never be modified or used for anything except its intended purpose.
• Before each use, an adult should review the product and battery to determine that no damage or hazards exist.
• DO NOT TOUCH SPINNING PROPELLERS. Do not allow anything to intentionally make contact in any way with spinning propellers or prevent contact with spinning blades by turning off remote prior to handling drone.
• Use caution and pay attention to your surroundings while operating drone.
• Do not fly drone into animals, people, or inanimate objects.
• Keep drone away from power lines, buildings, trees, public areas, and any other potentially hazardous areas.
• Do not operate in rain, heavy wind, and or any type of severe weather.
• Do not land drone on wet surfaces.
• Never touch or allow others to touch drone while it is flying.
• Always turn drone off when it is not in use.
• Always fly drone in large open areas.

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

REMOTE BATTERY INSTALLATION

1. Phillips screwdriver will be required for battery installation. Remove the screw at the back of the controller and then slide open the battery compartment.
2. Install 2 AAA 1.5V batteries, ensuring the correct polarity.
3. Replace and secure the battery compartment with the screw.

• This product contains batteries that are non-replaceable.
• There is a nsk of fire and personal injury it battery is punctured, damaged, or misused.
• Do not dismantle, crush, incinerate or short-circuit battery.
• Never expose battery to extreme temperatures or moisture.
• Keep away from flammable materials and direct sunlight.
• Only charge using the provided charger, cable, and or adapters.
• Rechargeable battery is only to be charged by an adult.
• Adult supervision is required while charging the battery, Allow battery to cool to room temperature before charging.
• Charge on a non-flammable surface and keep away from flammable products. Discontinue charging if battery becomes hot, swells, smokes, or gives off a strong odor.
• Battery chargers used with the product are to be regularly examined for damage to the cord, plug, enclosure, and other parts. In the event of such damage, chargers must not be used until the damage has been repaired.
• Recycle or dispose of battery according to federal, state, and local laws. Keep these instructions for future reference.

• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries. Alkaline batteries are recommended. Use only the specified voltage.
• Insert batteries using the correct polarity. Always use, replace, and recharge (if applicable) batteries under adult supervision.
• Do not attempt to charge non-rechargeable batteries,
• Do not short-circuit the battery supply terminals. Do not dispose of batteries in fire: batteries may explode or leak. Remove batteries before storing.
• Recycle or dispose of batteries according to federal, state, and local laws.
• Keep these instructions for future reference.

1. Turn off the drone before charging.
2. Connect the charging cable to the charging port on the drone.
3. Connect USB connector to the power source.

1. Only an adult should replace propellers. To remove, pull up the propellers directly.
2. Replace propellers by following the diagram.
3. Each propeller so ins differentia. Propeller B sins counter clockwise and Propeller A spins clockwise.

REMOTE OVERVIEW

OPERATING DRONE

Step 1 - Preflight Checklist

1. Read all warnings and instructions.
2. Install remote batteries, page 4.
3. Charge batteries, page 4.
4. Make sure that the drone and remote are powered off.

1. Drone is designed to be flown indoors and outdoors.
2. Always make sure you have enough space to fly the drone.
3. Always follow warnings, page 2.

1. Make sure the remote is off.
2. Press and hold the power button on bottom of the drone for 1 to 2 seconds until the LED lights turn on.
3. Place the drone on a flat, level surface. For ease of control, the blue lights should face towards you.
4. Turn on the controller. Push the left stick up and then down.
5. The drone's lights will flicker during the pairing process and then remain on once paired.

OPERATING

Step 5 - Operating Drone in Flight

1. Follow this step if your drone begins to drift during take off or during fight.
   • Drone drifts backwards: Press the Forward Trim button.
   • Drone chifts forwards: Press the Backwards Trim button.
   • Drone drift right: Press the Left Trim button.
   • Drone shift left: Press the Right Trim button.
2. Use the throttle to increase or decrease your elevation. Push the throttle to left, make the drone to rotate counterclockwise, Push the throttle to right, make the drone to rotate clockwise.
3. Use the directional contral stick to move forwards, backwards or side to side.
4. Stunts - Press the Stunt button then press the directional control stick in the direction you want to complete a stunt.

1. The stunt function may be disabled if the drone battery power is low.
2. Hover the drone at or above 10 feet before attempting a stunt.

1. Lower drone to below 20 feet then press the Take Off Land button. Use the directional control stick to maneuver drone. Or Push the left joystick down until the drone landing.
2. In the event the propellers will not stop spinning, you can perform an emergency stop by pressing and holding the red STOP button.

1. Turn off your remote. This will stop you from accidentally turning the propellers on.
2. Make sure the propellers have stopped spinning then pick up your drone. Press and hold the drone's on/off button to turn the drone off.

OTHER FEATURES

Auto OrientationPress the Auto Orientation button to turn the mode ON and then again to tum off,

1. In this mode, the drone will always move in the direction you press the Directional Control button no matter which way the drone faces. When drone is in auto orientation mode, the drone will orient to the user (remote), no matter what direction the drone is facing.
2. Press the Orientation button. Remote will beep every 6 seconds to indicate it is in Auto Orientation mode.
3. Push the right stick up will send the drone away from the user, push left will move left, etc.
4. Press Auto Orientation button to exit mode.

1. When powered on, the drone automatically starts in advanced flight mode. This mode features full flight performance and functionality.
2. to this ancrod time tis not resto an eaten is engine owe seer beep when the
3. To switch back to advanced fight mode, press the Training button again. You will hear 2 beeps when the drone enters advanced flight mode again.

1. Do not crash drone into sand or dirt, Drone gears may become clogged.
2. When first learning to pilot the drone, practice Fitting off and hovering indoors.
3. Stay several feet from walls and objects.

• Model Number: 1015713

Documents / Resources